Simple Lithophane Stands
Description
These are essentially simple lithophane stands, they are ready to print as-is, and hold the lithophanes securely, maybe not as tight as an exact fit, but due to the tolerances of my printer, I chose something that could be a bit more universal. The stand with the two holders is made for rectangular or square lithophanes (yellow in the 3d printed model) The smaller stand with only one holder is better suited for curved lithophanes, if the curve is too aggressive it might not be able to be accommodated. You may notice that the yellowish stand holder is a bit close to the circle for the candle, this was fixed in the model that is released. This was the first draft of the stand, so no worries in the STL you are receiving it should be fine. As you may have also noticed in the pictures, the space in front of the lithophane allows you to put small decorations. This can be done in your slicer very easily, allowing you to put personal touches with ease. In the case of the yellow stand, I put this owl: https://www.thingiverse.com/thing:465309 In the green stand I added: https://www.thingiverse.com/thing:3488999 There should not be any issues putting a candle in the hole area, a tea light will work quite fine, during my use I noticed that the lithophane will not be heated by the candle as long as there is no wind blowing the heat towards it, aside from that, I have left it with a candle for hours without any issues. This is one of my first 3D models so if there is any suggestions feel free to mention them!
Statistics
Likes
3
Downloads
0