PI / MKS SKR Mount
Description
This is my custom mount for a MKS SKR 1.3 Board on my Hypercube Evolution. It can also hold a raspberry PI, on which I run OctoPrint on. The two boards are connected over a direct serial connection via GPIO. I took the step on controll the SKR board only via OctoPrint so no Display is connected. To cool everything a little I used 120 Fan which I had laying around. But this is optional until the driver handles voltages where they need active cooling. There are two versions of the mount, since I also installed an optional beeper on the board. For assembly I used M3 screws and nuts for the SKR and M2 for the PI. The extrusions I mounted the mount are 3030's.
Statistics
Likes
0
Downloads
0