Mitsubishi Valve Stem Cap
Description
This is a simple remix of muzz64's design, removing the Makerbot logo and adding the Mitsubishi logo. This was made for my Evo X but will fit most car, truck and bicycle tires (Shrader valve equipped). Printed on a 0.5mm nozzle on 0.12mm resolution at 30mm/s. I would recommend a 0.4mm nozzle or smaller as the corners are much sharper. Raft recommended to avoid wobbling at the top on the print and don't use supports. Infill of 50% or more. I changed filament at layer 111 (Cura), verify in your slicer. Don't forget to share your makes!
Statistics
Likes
22
Downloads
0