Oculus Rift Sensor Cable Holder
Description
I created this small cable holder for the Oculus Rift Sensors, which I mounted on my walls. The cables were dangling everywhere and looked messy, so I designed this to help. It allows the cable to be pushed in and out of the clamping slot easily. It is mounted with a single picture hanging nail. See the nail's specs below. Nail Specs Nail Head - 4mm wide Nail Shaft - 1.7mm wide I printed this with no supports and 100% infill at 0.12mm layer height. The difference between the settings above and 20% infill and 0.2mm layer height is only about 3-4 minutes per piece (~13 to ~17). I also used a raft, but that is person preference and not required. The nail slides under the cable track and can be nailed in gently and sits below the surface as to not impede the wire placement. Once the head of the nail is below where a hammer can it without hitting the print, I used a small punch (or flathead screwdriver) with a hammer to put it in the rest of the way. The cable the clips in nicely. Please let me know if you have any improvements or suggestions!
Statistics
Likes
2
Downloads
0