Universal Propeller Duct Guard 4inches
Description
This is a duct for drones, created with software that performs fluid dynamics analysis. It guarantees 10-25% more efficiency depending on the type of propeller. The base where the motor is mounted is 2.5mm high so get some 2.5mm screws longer than those you normally use. DO NOT PRINT IN TPU, it is preferable to use a rigid material such as ABS or PETG, pla is not recommended because it is very fragile. I have saved the cure profile for ABS that I use with my cr10s so you don't waste time setting the print parameters. Last recommendation, be careful to mount them in the right direction of rotation (cw, ccw)
Statistics
Likes
2
Downloads
0