Squashball Feet Ender 3 V1 V2 Pro
Description
My take on the squashball feet for my Ender 3 V2 I didn't liked the other designs on here and wanted something i could screw on instead of something that has a T-slot design integrated. For an Ender 3 V1 or Pro you can use 4x the front feet. For the Ender 3 V2, the feet at the front are the same. At the back i've added a bigger hole which falls over the PSU mountingscrew. For mounting in the slots i've used https://www.thingiverse.com/thing:1061769. In total i used the following hardware: 14x DIN934 M4 Nut 14x DIN912 M4x10 Screw 14x DIN125A M4 Washer Also i've added a 'mountingslide', with this you dont need the Nuts and you can screw directly into the plastic. I would recommend with the mountingslide that you put screws in before assembly to tap the thread into the plastic.
Statistics
Likes
3
Downloads
0