Candle Vanity Tray
Description
This is a 40cm x 13cm candle tray my friend requested I design for her washroom. It is designed to print in two parts, sized suitably for printing on an Ender 3. I used triangular fittings, which will need some minor filing before gluing the parts together. Supports are not essential due to the small size of the fittings. I printed it with a 0.6mm nozzle at 10% infill and 0.32 resolution to save a bit of time. It's just being used as a decorative dish for washroom display in my case, after all. That used just over 300g of PLA and each part took just under 8 hours oat 50mm/sec. Add more infill and/or add walls when slicing You'll probably want some filler/primer at the very least to cover the connection line. I also used some Krylon fake stone spraypaint on top of the filler/primer to give it a little character and make it look more solid than it is.
Statistics
Likes
1
Downloads
0