The InDuctor Ender 3v2 (BLTouch in the duct)
Description
UPDATED VERSIONS HERE: https://www.thingiverse.com/thing:4881811 -BLTouch mounted in the duct in line with the nozzle optimizing bed probing area. -Large probe area; x 0-220, y 0-199mm. -No more incorrect readings from a slanted or unlevel gantry, the z-offset will always be the same. -Works with stock parts, only need hardware (m2+m3 screws). -Single or dual radial fans. -4010 or 4020 fans. -Lightweight 28g@20%infill, 44g@100%infill. -Parts cooling fan cools the parts, not the nozzle. -Large cooling area helps prevent cold spots and temperature differences that may cause warping or poor layer adhesion . -Stock parts cooling duct can bridge to 70mm quite well. Can bridge up to 100mm, but with some droppings. (Test done with 2 radial fans) -Easy install, no need to remove hotend. Probe offset x-0 y-36. Also added a file with supports as the generated ones just didn't jive. And now, a Spongebob version (untested), a probeless version, and one with the main body up raised 2mm as some ducts may be a little taller. Also, wouldn't hurt to have your hand on the power switch for the first z-home, just incase.
Statistics
Likes
40
Downloads
0