Bike AirTag Reflector
Description
**Small Update:** There's a rounded variant that I made to help reduce bending stress. and look a little better. This is a reflector and AirTag housing to somewhat discreetly hide an AirTag on your bike. Obviously it will be more discrete if you use black filament but I'm not too worried. This design is pre-toleranced but you may have to shave a little bit of the inside (of the top) and outside (of the bottom) base to get them to fit together if your printer squishes the bottom of prints. From there you should secure both halves using a zip tie that is 1.5mm thick and 5mm wide. The reflector was Cole branded and purchased from Bi-Mart.
Statistics
Likes
8
Downloads
0