Bush_C_D_144001
Description
Print these bushes in groups on your print bed with brims recommended. Prints well on CTC 10S so that being said most heated bed printers should be able to print these. Post processing requires you to drill/ream the hole to 2.5mm. Personally I drill 2.4mm them 2.6mm. PETG seems to close up a bit after being drilled so at 2.6mm still tight. Installing. You may think they don't fit, I did. I just pressed harder and they go in using pliers and pressing cup. PLA works fine. I would use flex materials but don't have the setup to print them. PETG is ideal. ABS is a good option to.
Statistics
Likes
0
Downloads
0