Arcade Quarter Dispenser / Holder
Description
Needed a better way of holding coins for the arcade, or for the wash - based loosely on [this thing](https://www.thingiverse.com/thing:3068593) but it didn't have all the features I wanted. Any coin that is similar to a quarter in dimensions should work, but probably not too much smaller as you would still need to fish it out with your thumb. Small markings denote a dollar in quarters, larger markings around the sides denote 5 dollars. Total capacity should be around 11-13 dollars depending on the compression of the springs you place. **Required**: - **(2)** 2-1/8 in. L x 7/16 in. Dia. Compression Springs **Printing**: Print one of each model for full assembly; .15mm or lower is recommended for layer-height. Large layer heights might make it difficult to screw the end-cap on or might cause issues getting quarters into the slot.
Statistics
Likes
5
Downloads
0