Buck Converter/Step-Down Converter USB Enclosure
Description
This is an enclosure for a step-down converter (AKA buck converter) that has USB out ports. See the photos to see the type of converter that this was made for. Step-down converters like these are usually needed if you plan to run your octopi raspberry pi off the printer's power supply, rather than its' own power adapter. Please refer to a guide on how to do this safely. The enclosure has a locking lid, and markings for wire polarity. There's also a slot to access the wire clamps after you close the lid. The slots in the lid are to let any heat out. I've added a mounting option for v-slots. Print the clip file twice and glue it into the holes in the bottom of the enclosure. If you don't want the clips, you can simply omit them and the box will have a flat bottom. There are a few supports needed for the lid clip holes and the small hole for the incoming wires. Make sure to pop out these supports before you try to close the lid, otherwise the clips in the lid might break off.
Statistics
Likes
10
Downloads
0