Half Bridge Load Sensor mount
Description
My version of a mount for a load cell. This is a single piece mount that holds the load cell using a little flange inside the housing, so that the load cell does not fall out. Printing: * Layer height: 0.25mm * Extrusion width: 0.48mm * Walls: 4 * Top/bottom layers: 3 * Infill: 40% A small screw (with a cap diameter less than 6.2mm) is used to attach it. To adjust the fit you can scale the model slightly. Assembly: https://youtu.be/HNgFiMNhTBk
Statistics
Likes
17
Downloads
0