tRodgFPV SourceOne v4 30deg Camera Couch
Description
After several failed prints with TPU on other designs, and realizing that all of them are for other frame versions (not v4, which I needed). I reverse engineered the hole pattern and made my own. Enjoy! ##My tried and true TPU for FlashForge Finder:## ##General:## Temperature: 210F Layer Height: 0.20mm First Layer Height: 0.20mm Base Print: 30mm/s Travel Speed: 30mm/s Minimum Speed: 5mm/s First Layer Max Speed: 15mm/s First Layer Max Travel Speed: 15mm/s Retraction Length: 4mm Retraction Speed: 45mm/s ##Perimeter## Shell Count: 2 Maximum Path Overlap: 50% Start Point Mode: Closest Permit optimized start point: Yes Exterior Speed: 100% Exterior Maximum Speed: 30mm/s Visible Interior/Invisible Interior Speed: 100% ##Infill## Top/Bottom Solid Layers: 3 Fill Density: 100% (make lesser to be lighter/weaker) Fill Pattern: Line Start Angle: 45deg Cross Angle: 90deg Overlap Perimeter: 70 Vase Mode: No Solid Speed: 100% Sparse Speed: 100% Infill: All Defaults ##Supports## None ##Raft## No ##Additions## Pre-Extrusion: Yes Margin: 5.0mm Path Length: 120mm Speed: 20mm/s Wall: No Brim: No Wiping Tower Speed: 60mm/s
Statistics
Likes
0
Downloads
0