3D Printed DIY Flight Simulator Pedals (Rudder & Brake) Using Arduino
Description
## MY YOKE: * https://www.thingiverse.com/thing:4855469 ## Pedal Controller For Flight Simulator (Rudder & Brakes) Using Arduino * 3D printable Pedal controls for Flight Simulator using Arduino. * Manual, wiring scheme, arduino code and setup instructions attached in the PDF file. * Assembly instructions at https://youtu.be/B3WRmVOTyvY * NOTE: some STL parts were created at a 20° angle from the base. ## Materials needed * PLA filament (or any other filament your printer accepts) * 3 B10K potentiometers * 1 arduino uno (original with Atmel microcontroller and DFU/reset pins) * MDF Wood base and screws * Wires * Springs
Statistics
Likes
280
Downloads
0