(Updated, Bearing-less) Steering Gear Conversion Kit
Description
Redesign of a redesign. This design no longer needs the bulky bearings and due to the change the baseplate now requires less supports. the steering rod has a cross for a rubber bands to be attached (see picture above) to make the steering wheel auto home when released. You will need: 1- Baseplate 1- LongSlide 2- 360 Gears 1- 1080 Gear 1- 900 Gear +1 900 Connector 1 Female (unchanged) 1 Female2 (updated) 3 connectors 1 CrossConnector (I would print 2 to 3 of these just in case at 100% infill as this is a part under a lot of stress and may likely break over extended driving sessions while using the rubber band homing. The old steering rods did this so to increase strength and reparability I made them both female with the cross holding them together so they more evenly distribute the stress from the rubber band and it can easily and fairly quickly be fixed in the event of breakage without having to print another steering rod. Depending on how it holds up I may rework the auto homing to remove the stress here)
Statistics
Likes
2
Downloads
0