Clay Pigeon Holder
Description
Here is a Clay Pigeon Holder I created in Tinkercad. all pieces should just pressure fit in place. if not just heat a bit to get them to fit, The settings I have used seem to work good Also like everyone, I do appreciate donations. please do not sell the one in the picture was on my Anycubic mega x, i have redesigned it to fit smaller build plates, same result any issues please reach out Thanks all Layer Height 0.3 10 Infill Print speed 60mm/s cooling 100% tree supports -touching build plate -support overhang -70.0` -support density - 10% Skirt adhesion
Statistics
Likes
2
Downloads
0