FastTrack Helmet Hanger
Description
This is a remix of a helmet hanger that I found that screws into the wall. I have a Rubbermaid Fasttrack system already installed in the garage with space available so I found a clip and added a cylinder that covers both of the screw halls. Once printed you will notice a small indent at the top and bottom. I chopped it up a bit for the ability to print a bit smaller to save time/material if that is more of a concern for you. I printed at 25% infill cubic subdivision since I printed this on it's side. If not worried about material one could print upright/upside down.
Statistics
Likes
6
Downloads
0