Camera mount for Logitech C270 in a Tukkari TS enclosure
Description
For my Tukkari TS model Prusa enclosure I created this camera mount to place my Logitech C270 webcam in the middle above the door, inside the enclodure with a clear view of the print bed. I printed in 0.2 layer height, 25% infill and no supports are needed. I did 3 Bottom and 3 Top layers, but less is also possible I think. Also I added a cable guide on the two brackets (corner and side bracket). The cable can be routed to the correct location inside the enclosure via these brackets.
Statistics
Likes
3
Downloads
0