Biqu B1 - H2 Mount
Description
Converting mount/mod for the Biqu B1 to use the Biqu H2 direct extruder. Shout out to Bart Geldof, for the original files that made all this possible! PETG for the Mount and Fan Duct. the Rest can be in PLA ------------------------------------------------------------------------------------------------------------------------- This are my Notes for this design. When Updating Firmware. Must Do this steps E Steps = 932 Probe Offset x = 31 y = -26 Home Offset x = 0 y = 0 Driver Current E = 800 mah (recommended for H2 by Biqu) Print Acceleration : 500 Run - g28 , g29 after every firmware update, to activated BL Touch Run - m500 to save Run - M92, to double check values/ settings ------------------------------------------------------------------------------------------------------------------------- Settings for Cura Print Temp : 200 Bed Temp : 60 Layer Height : 0.2 Retraction distance : 1 retraction Speed : 40
Statistics
Likes
13
Downloads
0