C920 Webcam Mount for CR-6 Max
Description
Decided I wanted to mount my Webcam on the tool head carriage so that diagnosing print failures would be easier. The design was simple enough, but dialing in the webcam focus took the longest. This might also fit the SE, not sure. I had to cut away the front of the tool head bracket to allow visibility. This will require a very small screwdriver to disassemble the webcam bracket. You will also need a 5mm+ longer m3 bolt for the new mount. You will likely need to turn off the webcams auto focus and set the focus manually through an SSH of the raspberry pi. sudo v4l2-ctl --set-ctrl=focus_auto=0 sudo v4l2-ctl --set-ctrl=focus_absolute=175 The absolute focus can be set between 1-255. 175 worked best for me.
Statistics
Likes
3
Downloads
0