Tortort Galil Trigger Layout Jig
Description
This is a layout jig for Tortort 80% Galil receivers. It indexes off of the already present 4mm rear trigger guard rivet location and has two "wings" on each side to keep it centered. Use a 4mm trigger guard rivet (or anything equivalent) to temporarily pin the jig in place, and then use a scribe to mark the receiver. Measurements came directly from Tortort's prints and they line up perfectly with my 100% Tortort receiver. Obviously, triple check all dimensions before cutting your receiver. I'm not responsible for your mistakes.
Statistics
Likes
2
Downloads
0