CR-10 Squash Ball Feet Tall Adjustable
Description
I wanted to lift my CR-10S5 up high enough to be able to fit the control box beneath it. These feet achieve that. They are adjustable. They can also help with leveling. You have to use them with 6 squash balls. I use the softest grade available (there are varying grades). The balls git in the holders tightly. BE CAREFUL, the edges are sharp. You'll also need some hardware to attach these to the frame. Specifically some t-nuts (https://www.amazon.com/dp/B07PMM7C44/ref=cm_sw_em_r_mt_dp_47332THQ15A9M1800J2G?_encoding=UTF8&psc=1) and some bolts to match. You may have extra from your original parts that came with the printer. I've found that the keeper screw is not necessary. The feet stay in place fine without it. I've also found that it's a little tight, so I just don't use it. You may have better luck if you make the diameter smaller. I use this on my CR-10S5, but as long as the aluminum frames are the same size, then I don't see why it wouldn't work on other CR-10s as well. I printed all of these without support. Anyway, have fun!
Statistics
Likes
1
Downloads
0