GoPro Hero 6 and 7 Sbang Case for Apex
Description
I needed a bit taller case for the impulserc apex frame because props were touching the other case i was using. Also i'm using the usb-c cable from tbs in order to use the gopro without battery so i added a small slot to pass through the cable without be afraid of props cutting it. I printed the case with sainsmart tpu and 50% infill and i don't think you will need more than this, at 50% it's pretty stiff. Important: As any GoPro mount for any quad you should print it sideways to avoid layer breakup on crashes. Note: It's 25 degrees. Thanks and #sendit #sbang
Statistics
Likes
1
Downloads
0