RaspberryPi 3 case, no screws Extrusion Mount w/40mm Fan
Description
I loved the original snap together design, but wanted to add a fan to help with the heat. So I made the top of the case taller which allows for a 40x10 fan. Also cut a hole to expose the gpio pins to allow for DLSR time lapse snapshots. Cut out a rear hole for a ribbon cable for a PI Camera. Lastly, added an extrusion profile to allow it the case to slide into an extruded aluminum frame. This top piece matches the bottom which can be downloaded here: https://cdn.thingiverse.com/assets/69/49/63/54/f4/rpi3_notft_bottom_2016_12_09_1000.stl
Statistics
Likes
4
Downloads
0