Smok nfix case
Description
Designed this case for my smok nfix with a hole in the bottom for a charging cable. Depending on your filament you make need to scale it up 1% to account for shrinking. I printed it in PLA, then tried to use heat to stretch it for a better fit, and noticed that it shrank after it cooled. Print standing up, 100% infill, and no supports. Brim may help prevent tipping over. I made a pathway for the button so it can clear that. I also made air holes on the side, but they need to be moved down about 3mm and enlarged a smidge. I didn't make it taller because it was too hard to grip the vape. This is part of a bigger project I'm working on....a charging case. I just need to find a suitable battery. Then I will create an all in one case with the battery, and zippo style lid, and possibly extra pod storage. I would also loosen the fit a little, because at that point it's mostly for pocket charging and storage. Enjoy.
Statistics
Likes
0
Downloads
0