3DUPFitters Prusa MMU2 Enclosure Bottom Edges
Description
Bottom Edge Pieces for the MMU2S Enclosure from 3DUPFitters. I didn't like how the bottom of this enclosure didn't retain its shape terribly well, and it slid all over the desk - plus for me at least one edge wasn't quite flush with the desktop. The corners and spacers help hold the bottom of the enclosure in a nice solid shape, and fill in any gaps on the bottom. The 4 corner pieces all have a cutout for adhesive rubber pads on the bottom, I used pads that were ~2mm thick and it sits near perfectly flat, but doesn't slide. You'll need 2 long and 1 short edges for the front, 4 long and 2 short for the sides (2 long and 1 short for each side), and 2 more long for the back. Back right corner piece includes cutout for the power supply cable grommet. Because of the cutouts, the corners will likely need supports to build plate only, haven't tried printing without.
Statistics
Likes
1
Downloads
0