Ender 3 V2 Y-Axis dual rail bracket
Description
Simple bracket to convert the Y axis of an Ender 3 V2 to dual linear rails. You will only need - this bracket - two linear rails linear rails MGN12C (15mm x 20mm) - 8x M3 screws (and washers if you want to distribute the torque a little bit) - 4x M5 screws (you can use the original nuts) There are also nice tools for the rail alignment here on thingiverse, you probably have to cut them in half or half print them to use them on the installed 40x40 profile. Good addition to my Ender 3/ 3 V2 X-Axis linear rail bracket https://www.thingiverse.com/thing:4910290 Improvements version 2: - Edges for generic end stops added on both sides Improvements version 3: - Installing can be a bit tricky, depending on print tolerances. Spring elements added. First thighten M3 screws of linear rails, then M5 screws of y axis plate.
Statistics
Likes
23
Downloads
0