Ultrasonic Cleaner Drainage Accessories
Description
This is a series of drainage accessories designed for the CO-Z 6L ultrasonic cleaner, but I'm sure it would fit any other of the cheap ultrasonic cleaners that look like the one sold by CO-Z. They're all designed to print on the plate of a SLA printer. If you do that, I recommend running the sliced file through the [Bulge Buster](https://nerdtronic3d.com/bulgebuster/) post-processing software to minimize the elephant's foot. They didn't leak in my tests, but I still put some PTFE tape on the threads to seal them. I've attached Fusion 360 files for your customizing enjoyment. Thread profile: 16mm x 1.25 pitch # Spout It provides a sharp low edge so that liquid doesn't dribble out on to the table as it drains. Print it spout-side down # Barbed Hose Connector Connector for a 12mm inner diameter hose. Use a hose clamp. Print it threaded side down. # 90 Degree Barbed Hose Connector Same as above, but with a 90 degree angle. Print threaded side down and add a couple supports for the right angle part
Statistics
Likes
5
Downloads
0