AK Mag Lip/Catch Mk.3
Description
Don't use PETG for small parts, the side will rip off. (P.S. vertical orientation: sides will rip off, Horizontal orientation: lip will rip off) Please print in the orientation I uploaded, the sides of the original file will rip of when printed in this orientation, to counter that I beefed up the design. Do file/sand until you can get it on, it'll be a tight fit. Lastly, Please use these settings `3 perimeters/walls `50-70 infill (if you're going to use ASA/ABS go with 30-40) `Stars/Triangle infill pattern `0.14 - 0.16mm Layer height This should print roughly around 20-40 mins tops. Big shout out to BrianAnim(the original creator) all credits to him. (I just helped, wink wink)
Statistics
Likes
4
Downloads
0