Cable Tidy Clip for Micro Swiss Direct Drive
Description
After fitting my Ender-3 Pro with a Micro Swiss direct drive I found that the cables were floating around at the extruder end. I came up with the idea of printing a clip to attach to the extruder stepper motor that the conduit could be attached to and save wear and tear on the cables connected to it. After several designs I settled on this one which has ventilation holes. The clip simply 'clips' over the stepper motor and you use 3mm tie-wraps / cable-ties to attach the conduit. Make sure there is enough length for the extruder to move to the extreme of the x-axis. I printed this in ABS but I'm sure would be just as good in PLA
Statistics
Likes
9
Downloads
0