K40 Laser Cutter 6mm OD Air Assist Hose Guide Mount / Stopper
Description
I wanted to keep my 6mm OD air assist hose from moving around without pinching it, so I made a mount that it just pushes into. I also created a stopper that's installed near the exit hole. It will keep the hose from being pulled too far out the back so that you maintain the proper amount of slack inside the unit. You'll need to a zip tie to keep it secured. Both mounts are held in place with 3M tape. If you want, you can buy me a coffee at https://ko-fi.com/vampyrex13
Statistics
Likes
4
Downloads
0