EZABL PRO Mount for Blokhead Fan
Description
Created this mount when the mounts for the TH3D EZABL Pro on Petsfang Blokhead were just to close for my use. Mounted on a Ender 5 Plus with the Micro Swiss Direct Drive setup. Spacing for firmware needs updating. Did a customer mount and from the head it was -51mm on the X and -16 on the Y. Your mileage may vary. Printed in PETG at .1 layer height and 3 perimeters. 30% infill. One screw holds it onto the printer.
Statistics
Likes
1
Downloads
0