Ender 6 Part Cooling Fan
Description
Intro: I created this fan-duct because the stock Creality E6 duct was touching my prints and ruined them by knocking them over when the print reached a certain height. So far this version have solved my issues, I hope others will find it useful as well. It is compatible with the majority of Creality printers so feel free to utilize it. ----------------------------------------------------------------------------------------------- Printing: Use 50mm/s and a 100% infill with 0,12 or 0.16 layer height, a brim is highly recommended the bigger the better. I used no supports but its up to you to decide whether its needed or not. PLA works just fine, it does not melt when used since the air is blowing through the fan. If you do not plan on using this fan a lot and you generally print without it turned on use PETG or PCTG.
Statistics
Likes
8
Downloads
0