Sewage Inspection Chamber channel blocker aka Shit Stopper 2000
Description
[If you find my designs useful, please consider sending a tip](https://www.paypal.com/paypalme/slegnor/1) An unused channel blocker for a sewage inspection chamber to stop unwanted "solid waste" getting stuck in the unused adjacent trough, when the water shoots out of the opposite pipe. AKA The Sh*t Stopper 2000. 3 versions, 2 variants for each 1: Straight & Straight With Holes 2: 45° left & 45° left with Holes 3: 45° right & 45° right with Holes Half-pipe diameter is approx 100mm and the rectangular plate is about 180mm for blocking the channel. These seem to be standard sizes for inspection chambers in the UK, so your mileage may vary if located elsewhere Held in place with waterproof / gutter sealant to stop any chance of it moving and blocking the pipe, but this also makes it permanently fixed in place, allowing easy removal. I added the holes variants as water can still accumulate in the channel from splashing and this will let it drain. Print Settings: Quality: 0.2 Infill: 10% Brim: Yes (Personal Preference) Supports: No Material: PLA
Statistics
Likes
0
Downloads
0