ResinLapse Adaptor
Description
Resinlapse was created to make it so you can take photos of your prints but on the Saturn, there isn't a convenient way to keep it in place at the vent hole beyond using tape. I designed this so it can be both held in place to work, but not have to worry about it getting too deep into the hole and being hit by the fan. Instructions: I printed it in PLA, standing up on the base. Put the ResinLapse sensor through the tube so it's sticking out just a tad past the base. Add the cap on the back, forcing the cord into a 90 degree bend. This will help prevent the sensor from pushing deeper into the printer and hitting the fan. Hold in place with a dab of hot glue. Use double sided tape to hold the base to the back of the printer. (Or tape over the larger section, but try not to cover any more of the fan vent than necessary!)
Statistics
Likes
0
Downloads
0