Kensington Expert Tenting Solution
Description
Simple tenting solution for the Kensington Expert mouse. I found the mouse put my wrist at a slight uncomfortable angle, even with the provided wrist wrest. This part raises up the mouse and wrist wrest slightly on the end towards the user, which resulted in a more comfortable angle for me. The cutouts on the bottom are so you can add 2 mm thick adhesive cork sheet for anti-slip. I printed in PLA with a 0.6 mm nozzle. There were some loose filament underneath where the cork sheet would cover due to a long bridge, but it is covered up and was no big deal for me. You could also place with slicer settings or add support material underneath when printing.
Statistics
Likes
0
Downloads
0