Tenere 700 fuel cap Hinge
Description
Printed in cura with supports only from the bed. Recomended to print in petg to avoid deformation in the sun. Tested on my bike with approval, it works as expected. Just needs 2 m4x16 rod like screws without the heads, since the plastic itself secures them like a locking nut. Or you can use a normal m4 screw but try to dont tighten the head against the plastic to much or it could break. Needs some double side tape to secure it to the plastic fairing. if the middle part is locking too much on the screw, just use a normal screw on it alone, and just screw it till the end and keep screwing to take of some of the material untill is good for you. :)
Statistics
Likes
6
Downloads
0