Hanging Spool Holder
Description
Yet Another Spool Holder. Just my take on a spool holder with bearings for a smooth ride. I didn't like any of the other hanging spool holders that I could find. I wanted to suspend the spool from a cabinet above my printers. This one incorporates 3 x 608 bearings to allow the spool to turn freely. They are spaced to cater for the common spool widths, so there should be at least two bearings in use at a time. It's been designed to limit bounce when filament is undergoing feed and extraction, which J shaped spool holders can suffer from. Printed with tree supports (at 5%) for the bearing holes. 15% infill at most, and a layer height of 0.25. Printed flat on a CR-6 SE.
Statistics
Likes
0
Downloads
0