ATX PSU USB Faceplate Only
Description
I have not printed this yet, just made the remix, my dins are still otw ATX PSU i am going to use the opposite side of the power switch, so i dont have to rewire the switch, i mean it works why change it, also right next to the plug so that works out just fin. This will allow me to pull my 5v and ground wires into the area right in front of the wire hole. I will then use a 3d printing pen to keep the usb din boards in place. and solder each usb separately, allowing me to pull 5v 5a per USB, should be enough for the phone and the rpi https://www.ebay.com/itm/124769027555 = usb 2.0 din
Statistics
Likes
0
Downloads
0