Garmin Striker 4 RAM Mount
Description
I designed this RAM mount for Garmin Striker Plus 4. It clips directly to the back of the unit and has a 1" ball mount which works with RAM mounts. the ball has been left slightly smaller than 1" to allow for heat shrink to be applied to the ball, this allows much better grip when tight so it won't move. the hole through the center allows a M4 x 35 mm screw with a hex nut for extra strength. Printing: Layer height 0.1mm Extruder temp 210c Print speed 40 mm/s Support - No Brim/Raft - No At layer 125: Changed extruder temp to 180 Print speed 50% (this helped print the overhang on the ball without supports)
Statistics
Likes
3
Downloads
0