T-Valve_I-Lube_Cap_Bearing
Description
Redesign of the T-Valve iLube Cap with a bearing, making it free from the spin of the twist. 2 type. One with a rubber seal, air seal is great but move less freely at least when the rubber seal is new. One with a lid, worse seal but move freely. Assembly is straightforward : Put the ring on the FL just under the screw (where the holes are), the rest is obvious. rubber seal version : Tvalve cap <-- seal <-- bearing optionnal : put a small quantity of (silicon) lube on the rubber to make the spin easier lid version : Tvalve cap <-- bearing <-- lid Parts : - 6811ZZ Bearing - Sanfor 57073 t.ly/u0tI https://www.amazon.com/Univen-Gasket-Stovetop-Espresso-Bialetti/dp/B08B38D74S/ref=psdc_13397451_t4_B000SOLUBQ It appear there's slight variation of the FL holder. If you can't fit the bearing with the main ring, use the ones slightly thiner. You may need to make for yourself if both don't fit. Update : Made a printable bearing in place of the 6811ZZ.
Statistics
Likes
0
Downloads
0