RaspberryPi Zero (2) snapfit case for ender 3 (pro) or v2
Description
i needed a case for the raspberrypi zero. i didn't want to use screws, so its snapfit. it doesn't require any support. the parts are already rotated in the right direction. it took me a lot of time to make this, so I hope it works for other people too. I wanned to keep it as clean as possible, so it's wired via serial. i use klipper with the fluid interface I use the case on an ender 3 pro with klipper. You can also add a fan it you want. i wired it to 24v, but you can also wire it to the pi zero on the 5v, if the fan is 5v. it's supposed to be a 30x30x10mm fan.
Statistics
Likes
4
Downloads
0