VR Retracting Spool ( LucidVR Glove)
Description
a retractable spool for use with LucidVR's Open glove https://hackaday.io/project/178243-lucidvr-budget-haptic-glove a cheap way to implement finger tracking using SteamVR. My printer is pretty old and I'm kind of bad at tuning it but, to make up for my lack of skill I designed a spool that's a bit more forgiving to print. It's only 2 parts! Please print with support everywhere for best results. --poorly written instructions-- >place pot in cut out and secure with nut on opposite side. >load "badge pulley" spring. coil the spring until its small enough to fit inside the rounded square compartment. Insert the spring tail into the inside the hole on the side and twist. the wall should be high enough to hold the spring in with no problems. Now is the time to add extra turns for extra tension. >Tie a knot in your string and pass the string through the small eyelet on the spool >load the spool with string >press fit spool onto the pot stem leaving roughly 4 or 5 inches available >pass string through eyelet on the small spigot at the bottom went through a couple more iterations. this should be pretty freaking solid now
Statistics
Likes
2
Downloads
0