Lathe Tool Mounts - 2020 Extrusion
Description
-0.8" Diameter Chuck Key Mount -Double Sided AXA QCTP Mount without Base -Double Sided AXA QCTP Mount with Base -Morse Taper 2 Mount -Morse Taper 3 Mount -Double Sided Morse Taper 2 + Morse Taper 4 Mount Uses M5 x 0.8mm Button Head Screws (McMaster Part #91239A241) and equivalent M5 2020 T-Nuts There is a sacrificial overhang on the M5 screw holes, so you will need to run a drill through them. The mounts for the chip guard are specific to a Precision Matthews PM-1022V & PM-1030V (Probably wont fit most lathes). There is a wide range of tolerances in the sheet metal width so you may need to shim or make adjustments for a tight fit on the chip guard. 1/4-20" thread is modeled in the print, but you may need to run a tap or screw through the holes with print resolutions higher than 0.2mm. .STEP Included in case you need to make changes.
Statistics
Likes
2
Downloads
0