X95 Tavor 7 pistol Grip
Description
Printed in PETG in the photo I printed it upside down, with supports under the grip, and trigger guard. The front edge of the trigger guard may curl, some did, some did not, so you may have to adjust settings. For ultimate toughness, I would increase infill; 20% with thick walls seemed pretty decent though. The front tab is a weak spot, as layer adhesion is very important here. May require slight adjustment to get it to fit perfectly. This is not a factory part, and has not been torture tested so any use of this at your own risk. Layer Height 0.2mm Wall thickness 3.0mm Top/bottom thickness 1.6mm Infill 20% 240c print temp 70c bed temp 40% fan (may have to alter to prevent curling) Brim
Statistics
Likes
1
Downloads
0