Step up Down Buck Boost Converter 35W DC 5.5-30V to 0.5-30V box
Description
Created this fairly rough, this is V1 as of 24/07/2021 this is for a basic box with button functionality so you can push the buttons inside and adjust the trims. this is for this boost module which I no way endorse and have not tested it for long so cannot comment on quality: https://www.amazon.co.uk/gp/product/B0876YQB6B/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1 Printing: Box - Infill 20% (id recommend higher purely for the lid mounting holes as they can break easily, possibly up to 40%) Buttons - Infill 100% Print 2 Lid - Infill 20% I printed the lid with a 1mm nozzle, box with 0.6mm and buttons with 0.4mm though smaller would be better however this took a total of around 4.5 hours to print. No supports needed for any of it. May need a Raft for the buttons which you need to print 2 of The buttons will come out a bit long but this is to suit adjustment if needed, you can fit any 3mm washer on the shaft before sliding it into the guide to take up any slack.
Statistics
Likes
0
Downloads
0