Onefinity Wire Cover with port for X & Z cables
Description
I have a cable chain setup on my Onefinity. To make the install cleaner, I hid all of my cables within the body of my table. More importantly, I didn't want to put more holes than necessary into my newly built table. At first I was going to design something from the ground up. On a hunch, I searched Thingiverse and found a couple of designs. My favorite one was designed by "Cybereefguru." It is a nice design and works great as it is but I wanted a slight modification to allow me to run my X and Z cables through the same hole as the Y1 cable. So, I downloaded his STL and modified it by adding a reinforced port on the left side that allows me to pass X&Z cables through it and to my cable chain rail. All the credit goes to cyberreefguru. He created a nice design, I just poked a hole in it... More importantly, he saved me about an hour of design work if I had to start from scratch.
Statistics
Likes
6
Downloads
0