2020 Extrusion Light Strip Mounts
Description
This set is for mounting LED light strips to 2020 extrusions. I've included 4 options to give a bit of versatility: 3 side mounts with mounting points at the higher, middle, and lower areas of the back, and 1 with a bottom center mount point. These were designed to work with my T nut design that requires no extra hardware and is completely printable. As always, these will be a tight fit, I recommend using needle nose plyers to grab the main body of the nut and twisting it into place. Then you can work it along the channel with the plyers until you groove the nuts to your preference, otherwise they will be pretty tightly anchored in place. If the mounting holes are too tight, you can ream them a bit to allow for an easier fit but be careful that you don't loosen them too much or your coupling will be loose/weak. I enjoy seeing others using my designs, so please post pics if you print. And comment any questions/comments as well. I also take request from time to time :)
Statistics
Likes
2
Downloads
0