Blower Bed Cooler
Description
Created a little attachment for a 5015 blower fan that I had laying about. Cuts the cooldown time of the print bed in half, allowing quicker removal of the part. Slides onto the edge of the bed (designed to fit 4mm thick bed) and allows air to flow over the top and bottom of the bed. Having air flow allows MUCH quicker removal of a fresh print. I'm no engineer and didn't run any airflow simulations... but I did my best to ensure an even distribution of air current. Seeing as my 5015 fan is 24v, I simply wired it into a 24v power supply that I stole from an aroma diffuser and added a switch. I'm sure a 12v or even 5v 5015 would work great too.
Statistics
Likes
1
Downloads
0